X86 debug register (Wikipedia Lab Guide)

X86 debug register
On the x86 architecture, a debug register is a register used by a processor for program debugging. There are six debug registers, named DR0...DR7, with DR4 and DR5 as obsolete synonyms for DR6 and DR7. The debug registers allow programmers to selectively enable various debug conditions associated with a set of four debug addresses.
Two of these registers are used to control debug features. These registers are accessed by variants of the MOV instruction. A debug register may be either the source operand or destination operand. The debug registers are privileged resources; the MOV instructions that access them can only be executed at privilege level zero. An attempt to read or write the debug registers when executing at any other privilege level causes a general protection fault.
DR0 to DR3
Each of these registers contains the linear address associated with one of four breakpoint conditions. Each breakpoint condition is further defined by bits in DR7.
The debug address registers are effective whether or not paging is enabled. The addresses in these registers are linear addresses. If paging is enabled, the linear addresses are translated into physical addresses by the processor's paging mechanism. If paging is not enabled, these linear addresses are the same as physical addresses.
Note that when paging is enabled, different tasks may have different linear-to-physical address mappings. When this is the case, an address in a debug address register may be relevant to one task but not to another. For this reason the x86 has both global and local enable bits in DR7. These bits indicate whether a given debug address has a global (all tasks) or local (current task only) relevance.
DR6 - Debug status
The debug status register permits the debugger to determine which debug conditions have occurred. When the processor detects an enabled debug exception, it will set the corresponding bits of this register before entering the debug exception handler.
DR7 - Debug control
The debug control register is used to selectively enable the four address breakpoint conditions, and to specify the type and size of each of the four breakpoints. There are two levels of enabling: the local (0,2,4,6) and global (1,3,5,7) levels. The local enable bits are automatically reset by the processor at every task switch to avoid unwanted breakpoint conditions in the new task. The global enable bits are not reset by a task switch; therefore, they can be used for conditions that are global to all tasks.
DR4 and DR5
Not real registers. On processors that support the CR4.DE bit (Intel Pentium and later), their behaviour is controlled by CR4.DE:
CR4.DE=0 : DR4 and DR5 alias to DR6 and DR7, respectively.
CR4.DE=1 : accessing DR4/5 results in #UD (invalid opcode) exception.
On processors without CR4.DE, the behaviour is officially undefined - usually, DR4/5 are aliased to DR6/7, but exceptions exist and have been used for CPU detection.
See also
Control register
Test register
References
Intel 80386 Programmer's Reference
External links
http://www.codeproject.com/KB/debug/hardwarebreakpoint.aspx Archived 2008-07-30 at the Wayback Machine Using the debug registers in Windows.
Source
- Wikipedia page: https://en.wikipedia.org/wiki/X86_debug_register
- Wikipedia API endpoint: https://en.wikipedia.org/w/api.php
